![]() ![]() Make sure that the crimp is tight and the wire is held in tightly. ![]() Because of this, they may wiggle loose in the add-a-fuse leading to an inconsistent current. Loose Wire in Add-A-Fuse - On some hardwire kits, the wire is much thinner than the socket on the add-a-fuse.Dash Mol2D Dash Mol3D Dash Speck Dash Ngl Using Dash Bio. If this happens, please contact us for a replacement. Dash Alignment Chart Dash Onco Print Dash Forna Container Dash Sequence Viewer Visualization tools. There might also be inline glass fuses on the cigarette cable or hardwire kit that can also be blown. I'm not at that point yet, but a question about installing the padded dash. Blown Fuse: If the fuse on the add-a-fuse is blown, the kit will not receive power. This is a discussion on 57 padded dash within the Early Birds 1955-1957 forums, part of the Thunderbird Model Years category I'm not at that point yet, but a question about installing the padded dash.Add-A-Fuse Incorrectly Set Up: If you don't put a fuse into the top fuse slot of the add-a-fuse, it will not feed power to the hardwire kit.A loose or weak ground may result in restarting when the vehicle hits a bump. Bad Ground: When an incorrect ground is used the camera won't get power.Please double check with your specific hardwire kit for the wire orientation and don't go off other guides. I then went to the OEM web site for the Dash Cams (Thinkware WEB Site) seeking additional information on features and installation of the Dash Cams. Reversed orientation of the accessory and ignition switched wires: The dash cam will behave abnormally if the wires are switched and in some cases even result in battery drain. The Ford Dash Cams (package) include a OBDII connector wire harness as the one option to install (and power) the Dash Cams.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |